**********************************************************************
Media Pro 4000 Brief			Date: September 29th 1999

  File:	TCM-4020_Set_Output_BR092999.txt
Module: TCM-4020, Time Code Module			
 Title: New Set OUTPUT token for TCM-4020
**********************************************************************

1)	Syntax & Example Usage: Set 'TCM' Output 1;

	a) Set @r0,0,0 Output 1; Will Turn the output on with the
            SMPTE Input as the source for the output.

		1) Note: If there is no SMPTE on the Input,
                    there will be no SMPTE on the Output.

	b) Set @r0,0,1 Output 1; Will Turn the output on with
            Internal (Seek/Play) as the source for the output.

		1) Note: If a Stop is sent to Port 1 the last frame
                    number (at the time the stop happened) will
                    continuously be sent on the Output.

	c) Set @r0,0,2 Output 1; Will Turn the output on with the
            Vsync Input as the source for incrementing the output.

		1) Note: If there is no Vsync Pulses on the Vsync Input
                    the last frame number (when the vsync pulses stopped)
                    will continuously be sent on the Output.

	d) Set @r0,0,3 Output 1; Will Turn the output on without
            changing the previously selected source for the output.


2)	Syntax & Example Usage: Set 'TCM' Output 0;

	a) Set @r0,0,0 Output 0; Will Turn the output off with the
            SMPTE Input as the source for the output.

	b) Set @r0,0,1 Output 0; Will Turn the output off with
            Internal (Seek/Play) as the source for the output.

	c) Set @r0,0,2 Output 0; Will Turn the output off with the
            Vsync Input as the source for incrementing the output.

	d) Set @r0,0,3 Output 0; Will Turn the output off without
            changing the previously selected source for the output.


3)	The new Set OUTPUT token is supported in TCM-4020 Firmware

	a) P/N 11105 PCB rev A should use Firmware TCM42D11 or Later.

	b) P/N 11105 PCB rev 0 should use Firmware TCM42D03 or Later,
            (but less than D09)


4)	Note: When the TCM front panel display switch is set to "Gen"
         the display will be --:--:--.-- if no source is selected
         for the output.

	a) Most likely cause, power on default mode set by Jumpers
            MD1 & MD2 is set to input only, and no cue commands
            have changed the source of the output since power on.

5)	Board Status now reflects the state of the output on bit 14

	a) Load @vVVV With @rR,S Status 0 Byte 0-3;

		1) Bit 14 (Byte 1, bit 6) will be ON if the
                    SMPTE output is disabled.

----------------------------------------------------------------------
Specifications subject to change at any time.

The data in this document incorporates proprietary rights of
Anitech Systems Inc., 25021 Anza Drive, Valencia, CA  91355  USA
Phone (661) 257-2184     Fax (661) 257-2025
Email Mail@Anitech-Systems.com     Web http://www.Anitech-Systems.com

Any party accepting this document does so in confidence and agrees that
it shall not be duplicated in whole or in part, nor disclosed to others,
without the consent of ANITECH SYSTEMS.